Stainless steel turbo exhaust manifold to suit R32 GTST R33/R34 Nissan Skyline RB20DET and RB20DET engine.
Designed to suit RB20DET engines and turbos with a T3 T3/T4 inlet flange (low mount). Set up to run an internal wastegate.
- 45mm diameter pipes to maximize air flow with 3/8" thick flanges for strong solid support.
- It fits stock turbo
- Pipes are 2.7mm thick.
- Fully polished
- Mandrel bent, TIG welded
- Huge weight reduction over standard cast manifolds.
- Increase exhaust flow significantly.
- Increase throttle response.
It fits:
NISSAN SKYLINE R32 RB20DET
NISSAN SKYLINE R33 R34 RB25DET
Please note: On the RB20 head, the water jackets line up a little different than the RB25. Same block, same head, same bolt pattern, however on the RB20 the port diameter is smaller than the RB25. The stock studs may need to be shortened.
This manifold has been designed for RB25DET and RB20DET. This high flow manifold is far more resistant to overboost problems
Reduce unwanted back pressure from your exhaust system with this low mount turbo manifold for your RB motor. This turbo manifold will allow for exiting gases to be routed more efficiently out of the exhaust system, giving you better engine response and more power.
Stock manifold not included.
Professional installation is highly recommended. Some of our products are designed exclusively for Off-Road and track racing only. It is a buyer's responsibility to check the laws.
Designed to suit RB20DET engines and turbos with a T3 T3/T4 inlet flange (low mount). Set up to run an internal wastegate.
- 45mm diameter pipes to maximize air flow with 3/8" thick flanges for strong solid support.
- It fits stock turbo
- Pipes are 2.7mm thick.
- Fully polished
- Mandrel bent, TIG welded
- Huge weight reduction over standard cast manifolds.
- Increase exhaust flow significantly.
- Increase throttle response.
It fits:
NISSAN SKYLINE R32 RB20DET
NISSAN SKYLINE R33 R34 RB25DET
Please note: On the RB20 head, the water jackets line up a little different than the RB25. Same block, same head, same bolt pattern, however on the RB20 the port diameter is smaller than the RB25. The stock studs may need to be shortened.
This manifold has been designed for RB25DET and RB20DET. This high flow manifold is far more resistant to overboost problems
Reduce unwanted back pressure from your exhaust system with this low mount turbo manifold for your RB motor. This turbo manifold will allow for exiting gases to be routed more efficiently out of the exhaust system, giving you better engine response and more power.
Stock manifold not included.
Professional installation is highly recommended. Some of our products are designed exclusively for Off-Road and track racing only. It is a buyer's responsibility to check the laws.